Simple timber batten

holzunterkonstruktion-einfach

Simple timber batten

Suitable for

Walls
Ceilings with minimal suspension height and even surfaces

Mounting

1) Mount base frame on wall with suitable mounting material and/or on load-bearing sections of ceiling

Panels must be allowed to stabilize/acclimatize on site for at least 48 hours prior to installation
Frame should be 50mm x 50mm, and minimum of 50mm x30mm; in this case 20mm spacing pieces are required (cavity = 50mm)
Frame spacing should be 600mm – 800mm
Fixings spacing (screw and/or plug spacing of 1000mm at most)
For panels with horizontal grooves, be sure to mount the frame vertically
Be sure to heed joint clearance in the timber batten as well (1mm per running meter)
Use a carpenter’s level to align the frame, using spacing pieces wherever necessary to even out irregularities
In order to achieve the desired sound absorption effect, insulating material at the level stipulated in the respective datasheet must be inserted in the cavity (in most instances this will be 50mm mineral wool of approx. 35kg/m³)

Perforated panels on timber batten with concealed screws

lochplatte-auf-holzungerkonstruktion
set_screw_image

Micro-perforation and stepped (graded) bores – wall installation using suspension strips

microperforation
In this type of assembly, the studs are mounted vertically.

Panels featuring an asymmetric hole placement (micro-perforated and stepped/graded bores) exhibit a tendency to warp. Thus we recommend screwing the suspension strips on to the non-perforated edge and gluing them to the panels in perforated areas.

Glue must be runny enough to penetrate the acoustic fleece backing in order for the strip to adhere directly to the panel.

Recommended product: Pur-Speed X-Press

Grooved panels on timber batten

Tongue-and-groove joints can be used with slat width of 192mm (standard width of grooved panels – slats).
nutplatten

Installation using impaling clips

Groove cheek width of 4mm
nutwangenstaerke